TOC removal of ultraviolet disinfection: TOC water recycling is a very critical parameter in the condensation line TOC analyzer can use in real-time, accurate detection of condensate water quality, TOC monitoring not only be able to judge whether or not the recovery of condensate, boiler can also be calculated Water supply and sewage emissions of industrial enterprises condensate recovery systems, boiler feed water systems and waste treatment systems have a significant impact. Power generation, petroleum, chemical, printing and dyeing, paper making, textile, brewing, rubber, ceramics and other industrial areas 2 Applications: TOC analyzer used in chemical, petrochemical and power plants condensate reuse TOC analysis; Technical parameters: Range: 0 ~ 2.000mg / L, 0 ~ 5.000mg / L, 0 ~ 10.000mg / L, 0 ~ 25.000mg / L, 0 ~ 50.000mg / L detection limit: at 25 ℃ and the range is 0 ~ 5000μg / L, the ≤5μg / L Response Time: T90≤5 minutes; T20≤3 minutes inlet pressure: 0.15 ~ 6bar sample flow rate: 25 ~ 200ml / min sample temperature: 2 ~ 70 ℃ Operating Temperature: 5 ~ 40 ℃ Analog Output: Two 4 ~ 20mA analog signal output, the user can set the corresponding output value. Alarm set: 5 alarm reported for the set - sample concentration alarm, alarm system alarm or system downtime. Serial communication: a versatile RS232 or RS485 serial interface (MODBUS, CSV) Power Requirements: 115 / 230VAC, 50 / 60HZ sample inlet: 1/4 inch OD tubing, pressure fitting outlet connections: 1/4 OD tubing, pressure fittings and drainage pressure: atmospheric carrier gas requirement: no air or nitrogen dioxide; the pressure is 2.8 ~ 6.2bar System Certification: CE, UL and CSA chassis Quality: IP66 / NEMA 4 Dimensions: 981mm * 675mm * 220mm equipment installation: wall-mounted instrument Weight: 54kg 4 main features: ● response time of less than five minutes, you can reach 100% oxidation; ● composition and oxidation by-products generated by the sample does not cause interference; ● use of reliable NDIR technology, ensure accuracy at low concentrations measured; ● advanced self-diagnostic function, self-cleaning system. ● detection limit of 5μg / L, specially designed for the condensation of water reuse. Into the multi-channel sample injection valve injection system, the sample is first acid oxidation, remove TIC; then the samples by UV oxidation reaction out of CO2 and water vapor are separated by separation device, separation of CO2 gas is sent to a non-divergent infrared detection , an infrared detector measures only the TOC, the infrared detector on the detection of CO2 has good detection sensitivity and linearity. TOC selection parameters Model rated flow m / h alarm indication gmp W power equipment out of the water pressure in diameter MPA cabinet sound and light alarm manual / automatic cleaning bolt bolt TRY-TOC-300 0.3 has 40 R1 / 2 0.6 has Optional Optional 6 M4 TRY-TOC-500 0.5 has 80 R1 / 2 0.6 optional optional 6 M4 TRY-TOC-1000 1 has 120 R3 / 4 0.6 optional optional 6 M4 TRY-TOC-3000 3 There are 160 R1 0.6 optional optional 6 M4 TRY-TOC-6000 6 has 320 R11 / 2 0.6 optional optional 6 M4 TRY-TOC-10000 10 560 R2 0.6 has an optional optional 6 M4 TRY-TOC There are 720 R2 0.6 -1,200,012 optional optional 6 M4 TRY-TOC-15000 15 800 R2 0.6 has an optional optional 6 M4 TRY-TOC-20000 20 900 R3 0.6 has an optional optional 6 M4 TRY- TOC-30000 30 1200 R3 0.6 has an optional optional 6 M4 TRY-TOC-40000 40 1500 R3 0.6 has an optional optional 6 M4 TRY-TOC-50000 50 1800 R4 0.6 has an optional optional 6 M4